Looking for a lower-cost alternative for your Clodbuster rear steer lockout? These 3d printed lockouts eliminate the need for any rear steering/lockout links at all! This design spreads the load across the axle C and inner knuckle surface, eliminating the chance of breaking the arm off of the steering knuckle. In fact, you can remove the arm completely for that ultra-clean look! These also allow both upper and lower 4-link mounting points to be used without interference. Sold in pairs and available in black or grey.
Note: Rear tie-rod is available as an option which provides additional protection for your axle tubes on hard landings.
CPE-LOC3p: Clodbuster Printed Rear Steer Lockouts
- Manufacturer: CPE
- Man. P/N: LOC3
- Stock Status: In Stock!