Looking for a lower-cost alternative for your Clodbuster rear steer lockout?  These 3d printed lockouts eliminate the need for any rear steering/lockout links at all!  This design spreads the load across the axle C and inner knuckle surface, eliminating the chance of breaking the arm off of the steering knuckle.  In fact, you can remove the arm completely for that ultra-clean look!  These also allow both upper and lower 4-link mounting points to be used without interference.  Sold in pairs and available in black or grey.

Note:  Rear tie-rod is available as an option which provides additional protection for your axle tubes on hard landings.